Fat Bike Cartridge B.B. Set for 120mm housing


Product number: BOT-BRA-UNI-120
Product information "Fat Bike Cartridge B.B. Set for 120mm housing"

Fat Bike Cartridge B.B. Set for 120mm housing

  • black
  • for 120 mm bottom bracket housing
  • total length (L1): 180 mm (~7,08 inches)
  • L2: 32 mm  (~1,26 inch)
  • ~ 400 gr.
  • BSA, JIS
  • sealed bearings
  • compatible with Shimano tools

0 of 0 reviews

Leave a review!

Share your experiences with other customers.

Cutsomers also bought

Bottom Bracket, 120mm BSA Shell Steel raw GB106
Bottom Bracket BSA Shell Steel Raw 120 mm (~4,72 inches) Steel, Raw outer Diameter 40 mm (~1,57 inches) length: 120 mm (~4,72 inches)

PAS KT-V12L Pedal Assist Sensor KT-V12L
PAS KT-V12L Pedal Assist Sensor Installation side: left Cable length: 130 mm Connector: 3-pin Julet connector, waterproof Fits e.g. e-bikes from Urban Drivestyle!

Claw for Ahead Head Set 1 1/8 UD5639
Claw for Ahead Head Set One time plug for 1 1/8 inch Thread M6

€1.95* €2.95* (33.9% saved)
Headset, 1 inch, black Y541
Headset 1" to be used with threaded front forks, black Size: A: 22,4 mm (~0,88 inches) B: 30,2 mm (~1,19 inches) C: 27,0 mm (~1,06 inches)

UD special headset Ahead 1 1/8 inch black UD100
UD special headset Ahead 1 1/8 inch black durable and high quality 1 1/8" headset Ahead for 1 1/8 inch shaft diameter color: black  sealed roller bearings Outer diameter bearing shell: 44 mm Original headset for the UDX from Urban Drivestyle in Berlin Not suitable for forks with threaded shaft!

Wiring harness 1T5, waterproof, 56 cm / 22,05 inches CAB-TRE-1T5-056
Wiring harness 1T4 Technical data: Transmission of power and data between e.g. the controller and the brake sensors, the thumb throttle and the display Waterproof plugs / connectors Cable length: ~ 56 cm / 22.05 inches, incl. connector ~ 66 cm / 26 inches Connections: 3x female 3-PIN Jullet connector yellow 1x female 5-PIN Jullet connector green 1x male 2-PIN Jullet connector red 1x male 9-PIN Jullet connector black General information: HIGO / Julet plugs are common on many e-bikes because they provide a firm and waterproof connection. There are different types, which differ in the number of pins and thus the area of use. A HIGO / Julet connector is generally quite firm because it is waterproof. It can be disconnected by pulling, NOT twisting. If twisted, the pins could be damaged. Please note the arrows on the outside - they help to align and fit the connectors. When the connections are properly plugged together, no coloured plastic should be visible.